Installing The Small Mounting Shelf; Removing The Center-Mounting Brackets; Installing The Mounting Hardware In An Open-Frame Rack - Juniper T640 Quick Start Manual

Hide thumbs Also See for T640:

Table of Contents

Repeat Step 4 and Step 5 for the other spacer bar.

Tighten all the screws completely.

Installing the Small Mounting Shelf

The small shelf installs on the back of the rear rails, extending toward the center of the

rack. See

Table 1 on page

Partially insert a mounting screw into the lowest hole specified in

Install the small shelf on the back of the rear rack rails. Rest the bottom slot on each

flange on one of the mounting screws.

Partially insert screws into the open holes in the ears of the small shelf.

Tighten all the screws completely.

The router is shipped with a spacer bar attached to the back of each front-mounting

flange, and two center-mounting brackets attached to the chassis. Remove the center

mounting brackets from the chassis by loosening the screws at the top and bottom of

each bracket.

To install the mounting hardware for an open frame rack:

Front-mount: Attach the large mounting shelf on the back of the rails. Remove the

center-mounting brackets from the chassis.

Center mount: Attach the large mounting shelf on the back of the rails. You do not

have to remove the center-mounting brackets from the chassis.

The small mounting shelf is not needed for open-frame

the holes in which you insert mounting screws, and cage nuts if needed.

Installing the Small Mounting Shelf

Table 1 on page

racks.Table 2 on page 10

specifies

Table of Contents