Setting The Source Route Ring Number - 3Com LANPLEX 6000 User Manual

Setting the Source
Route Ring Number
Top-Level Menu
system
display
ethernet
summary
mode
fddi
detail
ipFragmentation
tokenring
multicastLimit
ipxSnapTranslation
bridge
stpState
trFddiMode
ip
stpCost
addressThreshold
snmp
stpPriority
agingTime
analyzer
stpState srRingNumber
script
stpPriority address
logout
stpMaxAge
stpHelloTime
stpForwardDelay
srBridgeNumber
port
packetFilter
Slot 4 Ethernet port 3 - Enter new value [0x80]:
Slot 4 Ethernet port 4 - Enter new value [0x80]:
If your configuration was successful, you return to the previous menu. If the
configuration was not successful, you are notified that your changes failed,
and you can try to re-enter those changes.
The Source Route Ring Number is used by the token ring bridge when
Source Route traffic is enabled in SR and SRT modes. When combined with
the bridge number for the module and the ring number of the output port,
it serves to uniquely identify this bridge for forwarding of packets.
Values for the Source Route Ring Number range from 1 to 4095 and is
entered as a decimal number. The default value for this parameter is:
Default = slot number x 100 + port number
This parameter is only applicable to Token Ring and FDDI ports.
To set the Source Route Ring Number:
1 From the top level of the Administration Console, enter:
bridge port srRingNumber
You are prompted for the slot number(s) or
and FDDI ports.
2 Enter new value [1 through 4095].
Administering STP Bridge Port Parameters
to access all Token Ring
all
13-11
1
500