Replacing The Lsi1600 Or Lsi320-2 Card With Lsi320-2 - Avaya CallPilot 703t Maintenance And Diagnostics

RAID operations
16. Press F10 to configure the logical drives.
17. Highlight Accept and press Enter twice to accept these new values.
18. Highlight YES and press Enter.
19. Press ESC twice to exit the submenus.
20. In the Management menu, choose the Initialize submenu.
21. Press F2 to select the logical drive.
22. Press F10 and consecutively select YES to initialize the drive pack.
23. When the initialization is complete, press any key to return to the Management
24. Press ESC to exit the utility. Save the configuration when prompted.
25. Press Ctrl+Alt+Delete as indicated by the menu to reboot.

Replacing the LSI1600 or LSI320-2 card with LSI320-2

Use this procedure to replace a failed LSI1600 RAID card.
Warning:
Avaya strongly recommends that you not perform low level formatting. Performing low level
formatting results in the drives becoming unusable.
Important:
If your replacement RAID card has been previously used and holds an existing configuration,
the system will report a mismatch between the controller NVRAM and Drive MetaData. The
steps below will correct the mismatch.
To replace the LSI1600 or LSI320-2 card with the LSI320-2 card
1. Power up the server and click Ctrl+M to enter the utility.
2. Select Objects → Adapter → Other Adapter to set the following:
130 Avaya CallPilot® 703t Server Maintenance and Diagnostics
Result: The system prompts you for each of the logical drives to consecutively
select:
RAID 1; Size: accept the size displayed Accept SPAN = NO
Change the last value to NOSPAN if required.
Result: The system prompts you to save the configuration.
menu.
a. Set Force Boot to On.
b. Set Auto-Rebuild to Disabled.
December 2010