Table of Contents
Advertisement
Working with DIMMs and the CPU
3. Install the heat sink clips as shown in
156
Avaya CallPilot® 703t Server Maintenance and Diagnostics
Note:
See the top left corner of the microprocessor in the photograph in step
6
on page 153 on
c. Apply gentle downward pressure to the microprocessor to seat it in its
socket.
d. Lower and secure the lever.
e. Apply all of the thermal grease in the syringe that was provided in the
CPU assembly package to the metal square on the microprocessor.
f. Place the heat sink on top of the microprocessor, and then apply light
pressure in a circular motion to spread the grease evenly over the entire
metal square.
See also the description that follows.
Caution:
Risk of equipment damage
Ensure that you do not bend the wings of the heat sink while installing the clips
as this will cause damage to the heat sink.
6
on page 153.
Figure 34: Install heat sink clips
on page 157.
December 2010
Advertisement
Table of Contents
