Avaya CallPilot 703t Maintenance And Diagnostics page 123

7. Connect the floppy disk drive's signal cable to the drive.
8. Connect the power cable of the floppy disk drive to the drive.
9. Replace the upper fan holder foam.
10. Replace the side cover.
11. Reconnect the peripheral device and power cables.
12. Power up the server.
13. Test the floppy disk drive.
Avaya CallPilot® 703t Server Maintenance and Diagnostics
Note:
The connectors are usually keyed to allow you to easily reconnect them to the
drive. If they are not keyed, insert both cables so that the red wires are closest
to the center of the drive.
Caution:
Risk of data loss
If the floppy disk drive contains a floppy disk and the signal cable is connected
backwards, data loss can occur. The LED at the front of the drive will also remain
lit after the server is powered up.
Result: The floppy disk drive is installed.
For instructions on replacing the upper fan holder foam, see
fan holder foam on page 91.
To install a replacement floppy disk drive
To replace the upper
December 2010 123