Table of Contents
Advertisement
9. Reinstall the server side cover.
10. Reconnect the peripheral device and power cables.
11. Power up the server.
12. Rebuild the drive in the RAID system pack.
Replacing the tape drive
The tape drive is preinstalled at the factory. However, if it becomes faulty, follow the procedure
in this section to replace it.
Caution:
Risk of electrical damage
Use only a tape drive that is supplied by Avaya.
Filler panels and EMI shields
System EMI integrity and cooling are both protected by drives installed in the bays or by filler
panels and EMI shields covering the bays. When installing drives, save the panel and shield
to reinstall later, in case you remove the drive and do not reinstall one in the same bay.
Tape drive configuration
Note:
Some settings may already be properly configured. If it is not clear from the drive
manufacturer's documentation how to set jumpers, contact your Avaya technical support
representative.
Avaya CallPilot® 703t Server Maintenance and Diagnostics
• For instructions on replacing the upper fan holder foam, see
upper fan holder foam
The rebuild copies the data from the operating hard drive to the new hard drive. For
instructions, see
RAID operations
Result: Hard drive replacement is complete.
on page 91.
on page 125
Replacing the tape drive
To replace the
December 2010
113
Advertisement
Table of Contents
