Table of Contents
Advertisement
Replacing basic chassis components
1. Prepare the server for processor fan replacement as follows:
2. Disconnect the fan power cable connector from the server's motherboard.
3. Use both hands to spread the fan bracket tabs apart, and then move the fan away
4. Lift the fan up and out of the server.
Figure 18: install processor fan
102
Avaya CallPilot® 703t Server Maintenance and Diagnostics
a. Shut down the server, and then disconnect the power and peripheral
device cables.
b. Place the server on its side.
c. Remove the side cover.
d. Remove the upper fan holder foam.
For instructions,
seePreparing the server for hardware maintenance
Warning:
Risk of personal injury or equipment damage
Failure to follow the procedures
maintenance
on page 85 can result in electrical shock or equipment damage.
from the posts that hold it in place.
Tip: You may need to lift the bottom fan holder foam slightly to create more space.
inPreparing the server for hardware
on page 85.
December 2010
Advertisement
Table of Contents
