Avaya CallPilot 703t Maintenance And Diagnostics page 116

Replacing media drives
4. Attach the slide rails to the replacement tape drive with the screws you removed
5. Slide the tape drive into the tape drive bay.
6. Secure the tape drive to the front of the server with the screws you removed earlier.
7. Refer to the
8. Connect the power cable of the tape drive.
9. Replace the upper fan holder foam.
10. Replace the side cover.
11. Reconnect the peripheral device and power cables.
12. Power up the server.
13. Test the tape drive.
116 Avaya CallPilot® 703t Server Maintenance and Diagnostics
For instructions on changing the tape drive's settings, refer to the drive
manufacturer's documentation.
earlier.
Tighten the screws firmly.
Cabling diagram
cable as follows:
a. Connect one end of the SCSI cable to LVD (the wide SCSI controller of
the server) on the server's motherboard.
b. If a terminator is not attached to the cable, attach a wide SCSI terminator
to the other end of the SCSI cable.
c. Connect the second connector on the SCSI cable to the tape drive.
d. For proper cooling and air flow, neatly fold and secure the excess signal
cable into the last bay (at the bottom of the server) so that the cable does
not drape across the baseboard or add-in boards.
Caution:
Risk of equipment damage
Ensure that any cables in the proximity of the fans are kept away from
the fans. If a cable is caught in a fan, the fan will break.
Result: The tape drive is installed.
For instructions on replacing the upper fan holder foam, see
fan holder foam on page 91.
on page 105, and then connect the tape drive's SCSI
To replace the upper
December 2010