Table of Contents
Advertisement
Replacing media drives
4. Place the drive label-side up inside the carrier, and then attach the drive to the carrier
Figure 24: Attach disk drive to carrier
5. Install the drive carrier inside the server.
6. Secure the assembly to the server's front panel with the screws you removed earlier.
122
Avaya CallPilot® 703t Server Maintenance and Diagnostics
with the four screws you removed earlier. See
carrier
on page 122.
Ensure that the carrier is aligned with the two screw holes closest to the front of the
floppy disk drive. Tighten the screws firmly.
Slide the assembly toward the front of the system, and engage it with the bracket
tabs on the side of the drive bay.
Note:
The bottom of the drive/bracket assembly must accept the tab that sticks out from
the inside of the front panel. Ensure that the front of the drive fits flush in the front
opening of the system. (See the
overview
on page 120.)
Tighten the screws firmly.
Figure 24: Attach disk drive to
Figure 23: Floppy disk drive installation
December 2010
Advertisement
Table of Contents
