Table of Contents
Advertisement
4. Install the slide rails on the new drive.
5. Slide the new CD-ROM drive into the drive bay and secure it to the front of the server
6. Reconnect the CD-ROM drive's IDE cable to IDE0 (blue connector) on the
7. Reconnect the CD-ROM drive's power cable.
8. Replace the upper fan holder foam. For instructions on replacing the upper fan
9. Replace the side cover.
10. Reconnect the peripheral device and power cables.
11. Power up the server.
12. Test the CD-ROM drive.
Replacing the floppy disk drive
The floppy disk drive is preinstalled at the factory. However, if it becomes faulty, follow the
procedure in this section to replace it.
Caution:
Risk of electrical damage
Use only a floppy disk drive that is supplied by Avaya.
Avaya CallPilot® 703t Server Maintenance and Diagnostics
Note:
Refer to the CD-ROM drive manufacturer's documentation for specific jumper
settings.
Ensure that the first set of holes on the bracket are aligned with the screw holes
closest to the front of the CD-ROM drive.
with the screws you removed earlier.
motherboard. Ensure that the blue stripe on the cable at the motherboard connector
end faces towards the back of the server.
Important:
The server will not start if the cable is connected backwards.
For more information, see the
Result: The CD-ROM drive is installed.
holder foam, see
To replace the upper fan holder foam
Cabling diagram
on page 105.
Replacing the floppy disk drive
on page 91.
December 2010
119
Advertisement
Table of Contents
