Table of Contents
Advertisement
RAID operations
Task summary for configuring RAID
Note:
This summary should be used only after reviewing the more detailed procedures and
warnings in this chapter.
What to do
Verify the BIOS
and firmware
revisions
Upgrade or
downgrade
firmware and
BIOS
Configure RAID
using LSI 1600
controller using
the Ctrl+M menu
at server boot-
up
Note:
The Ctrl+M
utility can
take up to 1
minute to
launch with
111U
firmware. The
system may
appear
frozen. Do not
reset.
136
Avaya CallPilot® 703t Server Maintenance and Diagnostics
Firmware: 111U
Use the Windows MegaRAID console and choose Adapter → Properties.
Or turn on the server and press Ctrl+M. Select Objects menu → Adapter
→ Other Adapter Information.
Use the CallPilot 5.0 tower 703t Image CD-ROM 1 of 3 and select Utilities,
RAID 703t F/W upgrade.
1. Start the server and press Ctrl+M. Select Objects menu → Adapter
→ Factory Default, and select Yes to confirm the selection. Press
Ctrl+Alt+Delete when prompted to restart system and re-enter Ctrl
+M utility.
2. Select Objects → Adapter, then ensure the following values are set
as following:
Flex RAID Power Fail: Enabled
Fast Initialization: On
Disk Spin up Timing: 1 disk every 6 secs
Cache Flush Timings: Every 4 seconds
Rebuild Rate: 30%
Alarm Control: Enabled
Other Adapter Settings:
• Emulation: Mass Storage
• Auto Rebuild: Disabled
• Initiator ID: 7
• Cluster Mode: Disabled
• Multiple PCI Delayed Transactions: Disabled
• Force Boot: Off
• Coercion Algorithm: GigaByte Way
• Cc Restoration: Enabled
3. Select Objects → Channel, then ensure that the following values are
set as follows: Termination State: Enabled SCSI Transfer Rate:
160M
How to do it
December 2010
Advertisement
Table of Contents
