Avaya CallPilot 703t Maintenance And Diagnostics page 158

Working with DIMMs and the CPU
Figure 35: Install heat sink housing
5. Install the processor fan.
6. Replace the upper fan holder foam.
7. Replace the server's side cover.
158 Avaya CallPilot® 703t Server Maintenance and Diagnostics
a. Grasp the bottom edge of each side of the heat sink housing.
b. Spread the sides of the housing slightly, and then lower the housing over
the heat sink.
c. Release the housing to engage the tabs around the edge of the heat
sink's platform.
d. Apply pressure to the top of the housing and work with the bottom tabs
until the housing snaps into place. When all four tabs are secured, the
housing will not move.
For instructions, see Figure 18: install processor fan on page 102.
December 2010