Table of Contents
Advertisement
Replacing basic chassis components
2. Lift the tab on the bracket that holds the fan in place.
3. Angle the fan towards the interior of the server, and then lift it away from its slot.
4. Disconnect the power cable of the fan connector from the server's motherboard.
Figure 17: install rear system fan
5. Place the bottom edge of the fan on the support bracket at the back of the server.
100
Avaya CallPilot® 703t Server Maintenance and Diagnostics
b. Place the server on its side.
c. Remove the side cover.
For instructions,
seePreparing the server for hardware maintenance
Warning:
Risk of personal injury or equipment damage
Failure to follow the procedures
maintenance
on page 85 can result in electrical shock or equipment damage.
inPreparing the server for hardware
on page 85.
December 2010
Advertisement
Table of Contents
