To Run The Tracert Command From Windows; The Arp Command; Arp Command Syntax - Avaya CallPilot 703t Maintenance And Diagnostics

Table 7: Tracert parameters
Parameter
-d
-h maximum_hops
-j host-list
-w timeout
target_name

To run the tracert command from Windows

1. Click Start → Programs → Accessories → Command Prompt.
2. At the Command prompt, type the following command:
3. Press Enter.
4. Type Exit to exit the Command Prompt window and return to Windows.

The arp command

The arp command displays and modifies the IP-to-physical address translation tables used by
Address Resolution Protocol (arp).

Arp command syntax

The arp command uses the following syntax:
arp -s inet_addr eth_addr [if_addr]
Avaya CallPilot® 703t Server Maintenance and Diagnostics
Specifies not to resolve addresses to hostnames.
Specifies the maximum number of hops to search for the target.
Specifies a loose source route along the host list.
Waits the number of milliseconds specified by the time-out for
each reply.
Shows the name of the target host.
Result: The Command Prompt window appears.
tracert [-d] [-h maximum_hops] [-j host_list] [-w timeout]
[target_name]
Example: tracert 200.286.0.32
Result: The system runs the tracert utility.
To run the tracert command from Windows
Description
December 2010 43