Table of Contents
Advertisement
Stop
A Stop takes the component out of service immediately, regardless of whether the component
is currently processing calls. All active calls are dropped. Perform a Stop only when severe
problems affecting a large number of incoming calls occur or if your organization determines
a special need for it.
Components that can be started and stopped
The following components can be started and stopped when connected to a Meridian 1* or
Avaya Communication Server 1000* switch:
Note:
If you want to start or stop more than one or two multimedia or call (DS30X) channels, use the
Multimedia Monitor or Channel Monitor. For instructions, see
Monitors
Component
Media Bus
MPB board
Time Switch
Multimedia Channel
DS30X link
Channels
To start or stop a component
1. Run CallPilot Manager and login.
2. In CallPilot Manager, click Maintenance → Maintenance Admin.
Avaya CallPilot® 703t Server Maintenance and Diagnostics
on page 61.
Takes all call processing resources out of service.
Takes all call processing resources on the selected board out
of service.
You cannot perform maintenance administration on the time
switch.
Takes the selected Multimedia Channels out of service.
Takes the selected DS30X link and the channels that belong to
that link out of service.
Takes the selected DS30X channel out of service.
Result: The Maintenance screen appears.
Channel and Multimedia
Effect of stopping
Stop
December 2010
67
Advertisement
Table of Contents
