Table of Contents
Advertisement
Figure 34: Install heat sink clips
4. Use both hands to install the heat sink housing assembly as shown in
Avaya CallPilot® 703t Server Maintenance and Diagnostics
a. Align the side tabs on the clip over the heat sink guide.
b. Align the center hole on the clip over the tab on the heat sink guide.
c. Slide the clip forward or back until the tab is in the small portion of the
hole.
d. With both hands, apply even downward pressure on the ends of the clip
until it snaps into place over the end tabs on the heat sink guides.
Install heat sink housing
4.a
on page 158.
on page 158. See also the description that follows on
To install a new CPU
Figure 35:
December 2010
157
Advertisement
Table of Contents
