To Install A Replacement Cd-Rom Drive - Avaya CallPilot 703t Maintenance And Diagnostics

Replacing media drives
1. Prepare the server for CD-ROM drive replacement as follows:
2. Disconnect the faulty drive's power and signal (IDE) cables.
3. Open the front panel on the server.
4. Remove and save the two screws that secure the CD-ROM drive to the front of the
5. Pull the drive out of the chassis, and then place it on an antistatic surface.
6. Remove the four screws and two slide rails from the drive.
7. Place the drive in an antistatic protective wrapper.
8. Continue with

To install a replacement CD-ROM drive

Caution:
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.
1. Remove the new CD-ROM drive from its protective wrapper, and place it on an
2. Record the drive model and serial numbers in your equipment log.
3. Set the new CD-ROM drive to IDE Master by changing the jumper settings at the
118 Avaya CallPilot® 703t Server Maintenance and Diagnostics
a. Shut down the server, and then disconnect the power and peripheral
device cables.
b. Remove the side cover.
c. Remove the upper fan holder foam.
For instructions, see Preparing the server for hardware maintenance
Warning:
Risk of personal injury or equipment damage
Failure to follow the procedures in
maintenance on page 85 can result in electrical shock or equipment damage.
chassis.
Note:
If you plan to leave the bay empty, install a filler panel and stainless steel EMI
shield on the bay.
To install a replacement CD-ROM drive
antistatic surface.
back of the drive.
Preparing the server for hardware
on page 118".
on page 85.
December 2010