Avaya CallPilot 703t Maintenance And Diagnostics page 129

9. Select Objects → Channel and press Enter.
10. From the Channel menu, ensure the values are set as follows: Termination State:
11. Select Configure menu → New Configuration. Click Yes to proceed.
12. Create the first logical drive by selecting Channel-1 ID 0 (A01-01), and pressing the
13. Press Enter to End the Array.
14. Press F10 to configure the logical drive.
15. Press the space bar to select Configuration Array.
Avaya CallPilot® 703t Server Maintenance and Diagnostics
Flex RAID Power Fail: Enabled Fast Initialization: On Disk Spin up Timing: 1 Disk
every 6 secs Cache Flush Timings: Every 4 seconds Rebuild Rate: 30% Alarm
Control: Enabled Other Adapter Options:
• Emulation: Mass Storage
• Auto Rebuild: Disabled
• Initiator ID: 7
• Cluster Mode: Disabled
• Multiple PCI Delayed Transactions: Disabled
• Force Boot: Off
• Coercion Algorithm: GigaByte Way
• Cc Restoration: Enabled
Note:
The Coercion Algorithm must be set properly. Once changed, it cannot be
changed again. The only way to reset it is to reconfigure RAID from scratch and
load the default configuration, then reboot.
Enabled
SCSI Transfer Rate: 160M
Result: The system should display both SCSI channels, each having one drive.
SCSI IDs should be 0 for each channel. All disk drives should be in READY state.
Note:
Do not use the Load command on the Configure menu. This command is not for
RAID operations.
Spacebar. The display will change to ONLIN A01-01. Select Channel-2 ID-0
(A01-02) and again press the Spacebar.
Result: After selection, the drives will blink.
Result: The blinking stops.
Result: Span-1 appears in the box opened for the A01 logical drive.
To configure an LSI Elite 1600 RAID system
December 2010 129