Table of Contents
Advertisement
Troubleshooting your Avaya CallPilot® system
To check why server does not boot with fans turning
1. Ensure that the monitor is turned on.
2. If the problem continues, ensure that the internal power supply to the boards is
When the 703t server does not boot and the system board
LED is red
If the right-most status LED on the front of the 703t server is red, this is usually due to failure
of the Board Management Controller.
The most likely cause is changing boards without completely powering down the 703t server
and disconnecting the power cable.
To check why server does not boot and system board LED is red
1. Shut down the 703t server
2. Disconnect the power cable.
3. Wait 1 minute.
4. Reconnect the power cable and attempt to restart the 703t server.
5. If the problem continues, contact your Avaya technical support representative for
When the 703t server does not boot and makes audible
beeps
If beeps are short
If the beeps are short in length, they are from the system board.
Typically, you will not see any video displayed on the monitor, and the right-most status LED
on the front of the 703t server will show a blinking or steady amber.
32
Avaya CallPilot® 703t Server Maintenance and Diagnostics
connected correctly.
assistance.
December 2010
Advertisement
Table of Contents
