Replacing A Pcie Card - Avaya S8800 Manual

Replace the Avaya S8800 Server and its components
2. Press down on the riser-card assembly. Make sure that the assembly is fully seated
3. Install the cover.
4. Reconnect the external cables and power cords.
5. Turn on the attached devices and the server.

Replacing a PCIe card

Removing a PCIe card
Before you begin
Remove the PCI riser-card assembly.
About this task
Important:
Always use an electrostatic-discharge wrist strap or other grounding system when you work
inside the server. For more information, see
Procedure
Carefully grasp the card by its top edge or upper corners, and pull the card from the
PCI expansion slot. See the following figure.
30 Maintaining the Avaya S8800 Server for Avaya Aura
2
3
4
in the riser-card connector on the system board.
Comments? infodev@avaya.com
PCI riser-card assembly (full-height,
half-length PCIe cards)
PCI riser-card assembly (low profile
PCIe cards)
PCI riser connector 1
Protecting against ESD damage
®
Communication Manager
on page 10.
July 2012