Table of Contents
Advertisement
Caution:
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.
1. Prepare the server for floppy disk drive replacement as follows:
2. Disconnect the power and signal cables of the disk drive.
3. Open the front panel on the server.
4. Remove and save the two screws that secure the floppy disk drive to the front of
5. Slide the assembly toward the back of the server to disengage it from the tabs that
6. Remove the assembly from the chassis.
7. Remove the four screws that hold the bracket to the drive, and set them and the
8. Place the drive in an antistatic protective wrapper.
9. Continue with
To install a replacement floppy disk drive
1. Remove the new floppy disk drive from its protective wrapper, and place it
2. Record the drive model and serial numbers in your equipment log.
3. Set any jumpers or switches according to the drive manufacturer's instructions.
Avaya CallPilot® 703t Server Maintenance and Diagnostics
a. Shut down the server, and then disconnect the power and peripheral
device cables.
b. Remove the side cover.
c. Remove the upper fan holder foam.
For instructions, see
page 85.
Warning:
Risk of personal injury or equipment damage
Failure to follow the procedures in
maintenance
damage.
the chassis.
secure the carrier assembly to the server.
bracket aside.
To install a replacement floppy disk drive
component-side up on an antistatic surface.
To install a replacement floppy disk drive
Preparing the server for hardware maintenance
Preparing the server for hardware
on page 85 can result in electrical shock or equipment
on page 121.
December 2010
on
121
Advertisement
Table of Contents
