Table of Contents
Advertisement
RAID operations
corruption.
shows the accepted and tested combinations for Windows 2003
Table 18: RAID driver, firmware, and Power console configuration.
RAID card
LSI1600
LSI320-2
To determine the current RAID firmware version:
1. Select Objects Menu → Adapter → Adapter Information.
2. Launch the MegaRAID client using: Start → Programs → Power Console Plus →
3. From the MegaRAID Power Console Plus, Server Selection window, select Access
4. Select Adapter → Properties.
5. If the configuration is not one of the valid configuration in
Replacing the LSI1600 or LSI320-2 card with LSI320-2
Use this procedure to replace a failed LSI1600 or LSI320-2 RAID card.
To replace the LSI1600 or LSI320-2 card with the LSI320-2 card.
Warning:
Avaya strongly recommends that you not perform low level formatting. Performing low level
formatting results in the drives becoming unusable.
1.
110
Avaya CallPilot® 1002rp Server Maintenance and Diagnostics
Table 18: RAID driver, firmware, and Power console configuration.
Driver
6.45, 6.51 (6.36 works
temporarily but must be
upgraded)
6.45, 6.51 (6.36 works
temporarily but must be
upgraded)
Launch Client.
Mode → Full Access to view or change configuration information and click OK.
firmware, and Power console configuration.
update. For instructions, see
LSI320-2
on page 110.
Important:
If your replacement RAID card has been previously used and holds an existing
configuration, the system will report a mismatch between the controller NVRAM
and Drive MetaData. The steps below will correct the mismatch.
Firmware
111U
1L37, IL51
on page 110, perform a firmware
Replacing the LSI1600 or LSI320-2 card with
on page 110
MegaRAID Power
Console
5.00i, 5.00n
5.00i, 5.00n
Table 18: RAID driver,
December 2010
Advertisement
Table of Contents
