Table of Contents
Advertisement
Troubleshooting your Avaya CallPilot® system
Number of
beeps
3
3
3
3
3
3
SCSI controller diagnostics
BIOS initialization
Most information about SCSI is displayed as part of the BIOS initialization screen.
During BIOS initialization, check to make sure that the tape drive is listed correctly. If the tape
drive is not listed correctly:
• Ensure that internal cable connections are made properly.
• Check that tape drive settings are correct.
• Check tape drive termination.
For more information refer to:
•
SCSI and IDE drive cabling
•
Replacing the tape drive
RAID controller diagnostics
Most diagnostic information about RAID is available through beep warnings and status LEDs
when the server is rebooting.
30
Avaya CallPilot® 703t Server Maintenance and Diagnostics
POST code
06h
07-0Dh
0Eh
0Fh
DDh
EEh
on page 105
on page 113
Expansion card/controller
Decompressing post module failed.
Generic memory error has occurred.
SMBus protocol error has occurred.
Generic memory error has occurred.
CPU microcode cannot be found for
processor in slot 0.
CPU microcode cannot be found for
processor in slot 1.
December 2010
Advertisement
Table of Contents
