Hard Drive Led States - Avaya CallPilot 703t Maintenance And Diagnostics

Troubleshooting your Avaya CallPilot® system
LED position
Left
Right
IF the network interface
LED is
off
on
blinking rapidly

Hard drive LED states

The hard drive LED (the first LED in the row of LEDs below the power button on the 703t server
front panel) is not used because the 703t server is actually equipped with two hard drives.
There are no LEDs on the hard drives.
If hard drive faults occur on the 703t server, you can investigate them by reviewing events in
the following:
• operating system Event Viewer (see
• Avaya CallPilot Event Browser (see
You can also view the status of each hard drive in the MegaRAID Client. For instructions on
accessing and using this utility, see
22 Avaya CallPilot® 703t Server Maintenance and Diagnostics
Controller name
NIC1 10/100Base-T
NIC2 10/100/1000Base-T
a valid hardware connection with the network has not been
established.
Ensure that the Ethernet cable is connected to both the Ethernet
connector on the server and the respective network hub. If the
cable is connected, ensure that the cable is serviceable.
a valid hardware connection with the network has been
established.
Note:
Before the 703t server can receive or transmit data, you must
configure valid IP settings on the 703t server.
activity is occurring on the network.
Note:
This does not mean that the 703t server is actually
transmitting or receiving packets.
Viewing event logs
Event Browser
RAID operations
Controller type
ELAN
CLAN
THEN
on page 36)
on page 60)
on page 125
LAN type
December 2010