Table of Contents
Advertisement
Note:
The fan replacement kit contains four fans: two front fans and two rear fans.
To remove a front system fan
Caution:
Risk of equipment damage
Use an ESD wrist strap to protect static-sensitive components.
1. Prepare the server for front system fan replacement as follows:
2. Label and disconnect any cables that are attached to the voice processing boards.
3. Remove any add-in boards that block your access to the fan connectors on the
4. Lift the fan out of its slot in the fan holder foam.
5. Disconnect the fan power cable connector from the server motherboard.
Avaya CallPilot® 703t Server Maintenance and Diagnostics
a. Shut down the server, and then disconnect the power and peripheral
device cables.
b. Place the server on its side.
c. Remove the side cover.
d. Remove the upper fan holder foam.
For instructions,
seePreparing the server for hardware maintenance
Warning:
Risk of personal injury or equipment damage
Failure to follow the procedures
maintenance
on page 85 can result in electrical shock or equipment damage.
motherboard.
Note:
As you remove each board, label it with its slot number so that you can reinstall
the board in the same slot.
To remove a front system fan
inPreparing the server for hardware
on page 85.
December 2010
97
Advertisement
Table of Contents
