To Install A Replacement Tape Drive - Avaya CallPilot 703t Maintenance And Diagnostics

Note:
The tape drive is installed in the second bay from the top.
1. Prepare the server for tape drive replacement as follows:
2. Disconnect the power and signal (SCSI) cables of the faulty drive.
3. Open the front panel on the server.
4. Remove and save the two screws that secure the tape drive to the front of the
5. Pull the tape drive out of the chassis, and then place it on an antistatic surface.
6. Remove the four screws and two slide rails from the tape drive.
7. Place the drive in an antistatic protective wrapper.
8. Continue with

To install a replacement tape drive

1. Remove the new tape drive from its protective wrapper, and place it on an antistatic
2. Record the drive model and serial numbers in your equipment log.
3. Set the settings of the tape drive as described in
Avaya CallPilot® 703t Server Maintenance and Diagnostics
a. Shut down the server, and then disconnect the power and peripheral
device cables.
b. Remove the side cover.
c. Remove the upper fan holder foam.
For instructions, see
page 85.
Warning:
Risk of personal injury or equipment damage
Failure to follow the procedures in
maintenance on page 85 can result in electrical shock or equipment damage.
chassis.
Note:
If you plan to leave the bay empty, install a filler panel and stainless steel EMI
shield on the bay.
"To install a replacement tape drive
surface.
page 113.
To install a replacement tape drive
Preparing the server for hardware maintenance
Preparing the server for hardware
on page 115" below.
Tape drive configuration
on
on
December 2010 115