Table of Contents
Advertisement
What to do
Task summary for RAID splitting
Note:
This summary should be used only after reviewing the more detailed procedures and
warnings in this chapter.
What to do
Ensure that your
system is fully
working and the
RAID hardware
Avaya CallPilot® 703t Server Maintenance and Diagnostics
4. In the Configure menu, select New Configuration. Press Yes to
proceed. The system should display both SCSI channels, each
having one drive. SCSI ID's should be 0 for each channel. All disk
drives should be in READY state.
Note:
Do not use the Load command on the Configure menu. This
command is not for RAID operations.
5. Create the first logical drive by selecting Channel-1 ID 0 (A01-01),
and pressing the Spacebar. The display will change to ONLIN
A01-01. Select Channel-2 ID-0 (A01-02) and again press the
Spacebar. After selection, the drives will blink, press Enter or F10 to
create first logical drive.
6. Press the Space bar to Select Configuration Array. Span-1 appears
in the box opened for the A01 logical drive.
7. Configure the logical drives by pressing F10. The system prompts
for each of the logical drives to consecutively select
RAID 1; Size: accept the size displayed; Advanced Menu Accept
SPAN = NO Change the last value to NOSPAN if required. Accept
these new values by pressing Enter. The system will prompt you to
save the configuration. Highlight Yes and press Enter. Exit the
submenu by pressing Esc.
8. In the main menu enter the Initialize submenu. Select the logical
drive by pressing F2. Press F10 and consecutively select YES to
initialize the drive pack. When done, press any key to return to the
main menu.
9. Exit the utility by pressing Esc. Save the configuration when
prompted. Press Ctrl+Alt+Delete as indicated by the menu to reboot.
The most important thing to verify is that the RAID channel 1 is connected
to the first hard drive (top as facing the machine) and channel 2 is
connected to the second drive (bottom). Open the lid and follow the
cables or remove one hard drive and observe which drive is marked dead
Task summary for RAID splitting
How to do it
How to do it
December 2010
137
Advertisement
Table of Contents
