Member-Vlan - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.11.1
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
7.4.1.0
Usage Information This command causes the Ring Manager to take ownership of the two ports after IFM
validates the configuration. Ownership is relinquished for a port only when the interface
does not play a part in any control VLAN, that is, the interface does not belong to any
ring.
Related show frrp
Commands

member-vlan

Specify the member VLAN identification numbers.
C9000 Series
Syntax
member-vlan {vlan-range}
To return to the default, use the no member-vlan [vlan-range] command.
Parameters
vlan-range
Defaults none
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series.
Introduced.
— displays the Resilient Ring Protocol configuration information.
Enter the member VLANs using VLAN IDs (separated by
commas), a range of VLAN IDs (separated by a hyphen), a single
VLAN ID, or a combination. For example: VLAN IDs (comma-
separated): 3, 4, 6. Range (hyphen-separated): 5-10.
Combination: 3, 4, 5-10, 8.
Force10 OS Resilient Ring Protocol (FRRP) 889