Mac-Address-Table Station-Move Refresh-Arp; Mac Cam Fib-Partition - Dell Force10 Z9000 Reference Manual

mac-address-table station-move refresh-arp

Ensure that address resolution protocol (ARP) refreshes the egress interface when a station move occurs due to a
topology change.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax [no] mac-address-table station-move refresh-arp
Defaults none
Command Modes CONFIGURATION
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.7.1.0
Version 7.6.1.0
Version 7.4.1.0
Usage For details about using this command, refer to the "NIC Teaming" section of the Layer 2
Information chapter in the

mac cam fib-partition

Reapportion the amount of content addressable memory (CAM) available for MAC address learning forwarding
information base (FIB) versus the amount available for MAC ACLs on a line card.
E-Series
Syntax mac cam fib-partition {25 | 50 | 75 | 100} slot-number
To return to the default setting, use the no mac cam fib-partition command.
Parameters
25
50
75
100
slot-number
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
FTOS Configuration Guide .
Enter the keyword 25 to set aside 25% of the CAM for MAC address
learning.
Enter the keyword 50 to set aside 50% of the CAM for MAC address
learning.
Enter the keyword 75 to set aside 75% of the CAM for MAC address
learning.
Enter the keyword 100 to set aside 100% of the CAM for MAC
address learning. With this configuration, no MAC ACLs are
processed.
Enter the line card slot number. The range is 0 to 13 for the E1200, 0 to
6 for the E600, and 0 to 5 for the E300.
921