Dcb-Output - Dell C9000 Series Reference Manual

Version
9.9(0.0)
9.7(0.1)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information By default, iSCSI is enabled on the unit and the flow control is enabled on all of the
interfaces. It is also acts as defaults when the link-level flow control is enabled on one
or more interfaces.
To enable DCB, do one of the following:
Enables priority flow control or enhance transmission selection on interface.
Related dcb <ets | pfc> enable
Commands selection on interface.

dcb-output

To associate an ETS configuration with priority traffic, create a DCB output policy.
C9000 Series
Syntax
dcb-output policy-name
To remove the ETS output policy globally, use the no dcb output policy-name
command.
Parameters
policy-name
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON .
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
• Apply the dcb-input policy command with the no pfc-mode command on
to all the interfaces.
• Disable flow-control on all of the interfaces.
— enable priority flow control or enhanced transmission
Enter the DCB output policy name. The maximum is 32
alphanumeric characters.
Data Center Bridging (DCB) 697