Fcoe Priority-Bits - Dell C9000 Series Reference Manual

Version
8.3.16.0

fcoe priority-bits

Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
C9000 Series
Syntax
fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits
command.
Parameters
priority-bitmap
Defaults 0x8
Command Modes PROTOCOL LLDP
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.7(0.1)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information This command is available at the global level only.
Description
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the priority-bitmap range. The range is from 1 to FF.
Description
Introduced on the C9010.
Introduced on the S3048-ON and S4048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Data Center Bridging (DCB) 712