Show Cpu-Queue Rate - Dell C9000 Series Reference Manual

Usage Information In the show output, Rx Bytes displays the number of bytes of control-plane traffic
received, on which queue-based rate limiting is applied. Tx Counters displays the
number of bytes transmitted to a control-plane CPU after queue-based rate limiting is
applied. Drop Counters displays the number of bytes of control-plane traffic that have
been dropped as a result of queue-based rate limiting.
To clear the per-queue counters of rate-limited control-plane traffic at the aggregated
(switch), use the clear control-traffic queue command.
Example
Dell#show control-traffic queue queue-id 0 counters
Queue
---------------------------------------------------------
Q0
Dell#
Related Command clear control-traffic queue

show cpu-queue rate

Display the rates for each control-plane queue.
C9000 Series
Syntax
show cpu-queue rate [all | queue-id queue-number | range
from_queue to_queue]
Parameters
all
queue-id queue-
number
range
from_queue
to_queue
Defaults Not configured.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Rx Counter Tx Counter
5000 5000
Display the rate for all control-plane queues. The CPU queues
range is from 0 to 20.
Display the rate for a specified control-plane queue. The CPU
queue value range is from 0 to 20.
Display the rate for a range of control-plane queues. The CPU
queue value range is from 0 to 20. Separate the from_queue
value from the to_queue value with a space; for example, show
cpu-queue rate range 8 15.
Drop counter
0
Control Plane Policing (CoPP) 670