Debug Ip Bgp Updates - Dell C9000 Series Reference Manual

debug ip bgp updates

Allows you to view information about BGP updates.
C9000 Series
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name | ipv6
unicast [ipv6-address]] updates [in | out | prefix-list prefix-
list-name]
To disable debugging, use the no debug ip bgp [ip-address | peer-group
peer-group-name | ipv6 unicast [ipv6-address]] updates [in | out]
command.
Parameters
ipv6-address
peer-group peer-
group-name
in
out
Command Modes EXEC Privilege
Command History
Version
9.9(0.0)
9.2(1.0)
8.2.1.0
7.4.1.0
Usage Information Enter the no debug ip bgp command to remove all configured debug commands
for BGP.
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
followed by the prefix length in the /x format. The range is /0
to /128.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros.
(OPTIONAL) Enter the keywords peer-group followed by the
name of the peer group.
(OPTIONAL) Enter the keyword in to view BGP updates received
from neighbors.
(OPTIONAL) Enter the keyword out to view BGP notifications
updates sent to neighbors.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
Border Gateway Protocol 592