neighbor activate
This command allows the specified neighbor/peer group to be enabled for the current AFI/SAFI.
C9000 Series
Syntax
neighbor {ipv6-address | peer-group-name} activate
To disable, use the no neighbor {ipv6-address | peer-group-name}
activate command.
Parameters
ipv6-address
peer-group-name
activate
Defaults
Disabled.
Command Modes
ROUTER BGPV6-ADDRESS FAMILY
Command History
Version
9.9(0.0)
9.2(1.0)
8.2.1.0
7.4.1.0
Usage Information By default, when you create a neighbor/peer group configuration in the Router BGP
context, it is enabled for the IPv6/Unicast AFI/SAFI. By using activate in the new context,
the neighbor/peer group is enabled for AFI/SAFI.
neighbor advertisement-interval
Set the advertisement interval between BGP neighbors or within a BGP peer group.
C9000 Series
Syntax
neighbor {ipv6-address | peer-group-name} advertisement-interval
seconds
Enter the IPv6 address in the x:x:x:x::x format.
NOTE:
The :: notation specifies successive hexadecimal
fields of zeros.
Identify a peer group by name.
Enter the keyword activate to enable the identified neighbor
or peer group in the new AFI/SAFI.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the E-Series ExaScale.
Introduced
Border Gateway Protocol
597