Resetting Errors - Omron NX Series User Manual

5-4

Resetting Errors

Current errors in a Slave Terminal are retained, unless you reset them, until you cycle the power supply
or restart the Slave Terminal.
To reset errors, you must remove the cause of the current error. If you reset an error without removing
the cause, the same error will occur again.
Precautions for Correct Use
Resetting the errors does not remove the cause of the error.
Always remove the cause of the error, and then reset the error.
You can use the following methods to reset errors in a Slave Terminal.
Method
Commands from
Sysmac Studio
Commands from the
user program
Cycling the Unit
power supply to the
Slave Terminal
Note On the NS-Series PT, you can only reset all errors for the entire Controller.
Refer to the Sysmac Studio Version 1 Operation Manual (Cat. No. W504-E1-07 or later) for Sysmac
Studio operating procedures.
For details on the Reset EtherCAT Error (ResetECError) instruction, refer to the NJ-series Instructions
Reference Manual (Cat. No. W502).
NX-series System Unit User's Manual (W523)
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
Scope of error
Operation
Resetting Controller All errors in the Con-
errors troller
All errors in the
Slave Terminal
Errors for individu-
ally specified NX
Units
Clearing all memory All errors in the
for the Slave Termi- Slave Terminal
nal
Restarting Slave
Terminals
Resetting Controller All errors in the
errors in the Ether- EtherCAT Master
CAT Master Func- Function Module
tion Module
--- All errors in the
Slave Terminal
reset
Reset the Controller error from the Trouble-
shooting Dialog Box on the Sysmac Studio.
Refer to the user's manual of the Communi-
cations Coupler Unit for details on resetting
errors in the EtherCAT Slave Terminal.
If the causes for the Controller errors are
removed, all Controller errors in the Slave
Terminals are reset.
Execute the Reset EtherCAT Error
(ResetECError) instruction in the user pro-
gram of the NJ-series Controller.
If the causes for the Controller errors are
removed, all Controller errors in the Slave
Terminals are reset.
5 Troubleshooting
Description
5 - 11
5