Auto Start; Exiting The Power Saver Mode - Fuji Xerox 1015S Series Instruction Manual

Switching to the Power Saver Mode manually
You can also switch to Low Power Mode manually.
Once the machine is in the Low
Power Mode, it will enter the Power
Saver Off Mode if the machine
continues to be left idle for a fixed
period of time. The power is then cut
off from the machine. When you
need to make copies, switch on the
power of the machine.

Exiting the Power Saver Mode

You can exit the Low Power Mode by pressing the Power Saver button.
The Power Saver Off Mode refers to the state when the power of the machine is switched to the
(Off) position.
To make copies, switch on the power of the machine.
1.2.3

Auto Start

While waiting for the machine to warm up after the power is switched on, you can press the Start
button to program copying. This feature is called Auto Start.
Enabling Auto Start
To use the Auto Start feature, load the document, specify the desired settings and then press the Start
button.
The message "Please wait ... The job will start automatically." will be displayed and copying will begin
automatically once the machine has entered the Ready to Copy mode.
If you have set the machine ready tone in Tools Mode, you will hear the tone when the machine has warmed up and is ready to
accept copy jobs. You can then proceed to set an Auto Start job after the tone. To set the machine ready tone or change its tone
volume, refer to "8.3 Setting Tools Mode".
Procedure
1
Press Power Saver.
The machine enters the Low
Power mode. When you need to
make copies, press the Power
Saver button.
1.2 Switching On/Off Power
"
"
9