Table of Contents
Advertisement
The Stop button for stopping any ongoing copying
Press the Stop button on the control panel to terminate a copy job that is in progress. Once you
have pressed the Stop button, the copy job will be suspended and the following message will be
displayed: "Press Start to continue or C button to cancel."
To resume the copy job, press the Start button again. To stop the job, press the C button.
The Clear All button to cancel feature settings
To clear all the settings of the selected features, press the Clear All button on the control panel.
Once you have pressed the Clear All button, all settings will return to their default settings when the
power of the machine is on. The Clear All button cannot be used when copying is in progress.
The settings can automatically return to their default settings by setting a timer. Refer to "8.2
Overview of Tools Mode".
The C (Clear) button for correcting the number of sets for copying
Press the C button on the control panel to clear any error when entering the number of sets to be
copied. Once you have pressed the C button, the number of sets will return to "1". No other settings
will be changed.
The Stop button for changing the number of copies for any ongoing copying
You can change the number of copies on the screen to be displayed when pressing the Stop button
on the control panel (or Stop on the screen), except Collated is activated.
Automatic tray switching
This feature allows the machine to automatically switch to another paper tray with paper of the same
size, orientation, and type to continue with the copy job, when paper in the specified tray runs out.
This feature is called Automatic Tray Switching (ATS).
This feature is enabled by the Tools Administrator in Tools Mode.
All trays have this feature enabled as the factory setting.
If all trays are loaded with paper of the same size, type (normal paper) and orientation, the trays will
be switched in the order of trays 1, 2, 3, and 4.
The factory setting can be changed in the Tools Mode. For details, refer to "8.3 Setting Tools Mode".
When the optional HCF is equipped, the trays will then be switched in the order of tray 6 (HCF), trays 1, 2, 3, and 4.
4.1 Basic Copying Procedures
51
Advertisement
Table of Contents
Troubleshooting
