Fuji Xerox 1015S Series Instruction Manual page 125

When Z Fold is selected with
stapling/punching, the number of
copies may be different from the set
stapled/punched only.
When the positions for punching and
stapling are in conflict (e.g. stapling
on the top left and punching on the
right), the machine will not start even
if you press the Start button. Check
the positions again.
3
Select On for Z Fold.
Finishing
Auto
Collated
Stapled/Punched
Uncollated
When selecting Z Fold with stapling/punching:
The copies are stapled as shown below depending on the position(s) specified
for stapling or punching holes.
When Top Left is selected
Stapling
left side
(1)Select Collated/Stapled/Punched and specify the position
to be stapled or punched.
(2)Check Original Orientation.
4
Select Save to specify settings for other features if necessary.
5
Press Start.
Copies will be made and output to the finisher tray.
Large Output Punching Original Orientation
Off Off
On Left
2 Holes
Top
2 Holes
Right
Z Fold
2 Holes
Left
4 Holes
Top
4 Holes
Right
4 Holes
When Top Right is selected
5.7 Z-Folding
Cancel Save
Head to Top
Head to Left
Off
On
Large paper is
folded to align
with paper
edges.
Stapling
right side
99