Fuji Xerox 1015S Series Instruction Manual page 202

5.32 Copying Documents of Different Settings (Build Job)
To cancel Build Job, select End Job
and after you have checked the
screen that appears to prompt you
for confirmation, the display returns
to the initial Build Job screen, where
the setting for the very first
document is not specified yet.
When clearing the settings of Build
Job, select any other mode (e.g.
Copy).
176
7
Select Next.
When On is selected, the files set for Build Job are saved for copying or
merging later.
When Off is selected, the files set for Build Job are not saved.
Build Job
Select Next to program and scan the next job segment.
Or, select Cancel Job to cancel Build Job.
Or, select End Job (Save File) to save the file without making copies.
Or, select End Job (Sample Set) to make a proof set of the Build Job for review.
Or, select End Job (Start) to make the required number of sets straightaway.
Note: The file for Build Job will be deleted if Save to File is set to Off.
Save to File
Off
On
The Copy screen is displayed.
8
Load the next document and repeat the steps above as
necessary.
9
Enter the number of copies by using the keypad.
A value input after all the documents are scanned becomes valid as the number
of copies.
10
End Build Job.
When making sample copies:
When making multiple copies, you can first copy one set as sample to check
the results.
When copying the remaining sets, the number of sets copied will be the number
specified less the sample set.
(1)Select End Job (Sample Set).
Build Job
Select Next to program and scan the next job segment.
Or, select Cancel Job to cancel Build Job.
Or, select End Job (Save File) to save the file without making copies.
Or, select End Job (Sample Set) to make a proof set of the Build Job for review.
Or, select End Job (Start) to make the required number of sets straightaway.
Note: The file for Build Job will be deleted if Save to File is set to Off.
Save to File
Off
On
End Job End Job
Cancel Job
(Save File) (Sample Set)
End Job End Job
Cancel Job
(Save File) (Sample Set)
Next
End Job
(Start)
Next
End Job
(Start)