Loading Paper In Tray 5 (Bypass) - Fuji Xerox 1015S Series Instruction Manual

2.2 Loading Paper/Changing Paper Size of Paper Trays
2.2.2

Loading Paper in Tray 5 (Bypass)

Load the following paper in tray 5 (bypass): transparency, postcard, heavy weight paper and other
special and non-standard size paper that cannot be loaded in trays 1 - 4 and the optional tray 6
(HCF).
When making copies onto SRA3 (320×450mm/12.6×17.7") or 12×18" paper, shift the paper guide on
the bypass tray before copying.
Always remember to shift the paper guide back to its Standard position after the copying is done.
For details on the type of paper that can be loaded in tray 5 (bypass), refer to "2.1 Paper to Use".
2-sided copying cannot be done with tray 5 (bypass).
For details on loading the side for copying (face up/down) and paper orientation, refer to "5.26 Copying With Covers" and
"Appendix C Originals/Copies Orientation (With Covers)".
If the paper guide has been moved
to the 12"/305 mm or 12.6"/320 mm
position, shift it back to its Standard
position.
Do not shift the paper guide unless
you are copying onto SRA3
(320×450mm/12.6×17.7") or 12×18"
paper. Usually, the paper guide
should be at its Standard position.
28
Procedure
1
Open tray 5 (bypass).
If necessary, pull
extension flap. The extension flap
can be pulled out in two steps.
2
Check the position of the
paper guide, which
located as shown in the
diagram on the right.
Usually, the paper guide should
be at its original position.
When loading paper:
Proceed to Step 3
When changing the paper size:
(1)Loosen the screw on
the right of the paper
guide.
out the
is