Entering/Exiting Tools Mode - Fuji Xerox 1015S Series Instruction Manual

Select Back to exit the System
Administrator Mode.
8.1.2

Entering/Exiting Tools Mode

The following procedure explains how to enter or exit the Tools Mode.
After switching from the main control panel to the copier control panel, you can start to use the Tools
Mode.
In Tools Mode, you can change the default settings of the features displayed, or change the image
quality and the machine setting status.
You need to enter the Tools password in order to access Tools Mode.
You cannot switch to Tools Mode if there is an error message shown on the display. Check that "Ready to copy", "Please wait..."
or the Auditron Administrator Password Entry screen is displayed.
The factory setting of the Tools password is 11111. This password can be changed. For security reasons, change this password
as soon as possible. For details, refer to "8.3.2 Changing Tools Password".
After a while, the following screen is displayed and operation is switched from
the main control panel to the copier control panel.
To return to the normal programming screen, exit administration mode
using the control panel of the copier and select Back on this screen.
The control panel of the copier is in front of the Document Feeder.
4
Lift the cover of the copier
control panel to start using
the panel.
Switching to the copier control panel is complete.
8.1 System Administrator Mode
Back
293