Table of Contents
Advertisement
When the optional finisher is installed, this feature allows you to output copies with punched
holes.
You can select the number of punch holes from 2 Holes or 4 Holes.
Suitable paper sizes for punching and punch positions
The following paper sizes and positions are suitable for punching:
Paper size
B5 portrait,
A4 portrait,
8.5×11" portrait
2 Holes
A4, B4, A3,
A4 portrait,
8.5×11" portrait
4 Holes
A3, 11×17"
Document orientation
Follow the diagram below for loading in the Head to Left orientation:
A message appears prompting you to empty the punch scrap container when it is full. If this message appears, empty it by
referring to "10.6 Emptying Punch Scrap Container".
When the positions for punching and stapling are in conflict (e.g. stapling on the top left and punching on the right), the machine
will not start even if you press the Start button. Check the positions again.
Punching cannot be carried out if tray 5 (bypass) has been selected.
Punching cannot be carried out for paper loaded in tray 7. This limitation can be changed by means of a customer engineer
setting. Contact your Customer Support Center.
When tray 7 is selected in the copying settings, punch positions for paper loaded in trays 1 to 6 are limited as follows. This
limitation can be changed by means of a customer engineer setting. Contact our Customer Support Center for details.
• When Head to Top is selected for document orientation: The left side
• When Head to Left is selected for document orientation: The top side
The Transparency option cannot be selected together with Repeat Image.
94
Punching Holes
5.6
Position
Top
11×17"
Left
Right
A
A
A
A
A
A
A
A
Finishing
Advertisement
Table of Contents
Troubleshooting
