Fuji Xerox 1015S Series Instruction Manual page 18

Safety Notes
Sudden temperature fluctuations can affect copy quality. Rapid
heating of a cold room can cause condensation inside the
machine, directly interfering with image transfer.
Precautions on Power and Earth Connections
Three power specifications are listed below.
The specifications that apply to your machine
depend on your
Connect the plugs directly to sockets with the
equivalent or higher rates. Never use multi-
plug adaptors to connect multiple plugs to the
same socket as it can lead to overheating and
cause electric shock or fire. If in doubt, contact
your Customer Support Center.
Rated voltage: 100 V
Two electric cords with the rates of 100 V/
15 A and 100 V/5 A, are provided.
Check the labels pasted on the machine.
Rated voltage: 200 V
Rated current: 15 A
Rated voltage: 220-240 V
Rated current: 15 A
For the 100 V model, the combined electric
current of the two electric cords is 20 A.
Before inserting any electric cord to a socket,
check the allowed electric current of a branch
circuit of the switchboard in use, which is
usually 20 A. Never connect any other
electrical appliances to the socket used for
this machine.
Ensure that the plug connection is free of dust.
In a damp environment, a contaminated
connector can draw a non-negligible amount
of currect that can generate heat and
eventually cause fire over an extended period
of time.
For the 100 V model, do not use any
extension power cord less than the rate of 125
V/15 A. Also, do not connect more than one
power cord to the extension power cord.
Overloading can cause fire. Contact your
xviii
machine configuration.
Do not expose the machine to direct sunlight.
Exposure to direct sunlight can adversely
affect the machine's performance.
Customer Support Center if you need to obtain
an extension cord.
Do not attempt to rework, pull, bend, chafe, or
otherwise damage the power cord. Do not
place a heavy object on the cord. A damaged
cord can cause fire or electric shocks.
Never touch a power cord with wet hands.
Danger of electric shocks exists.
Stop operation immediately if your machine
produces smoke, excessive heat, unusual
noise, or smell, or if water is spilt onto the
machine. These conditions can cause fire.
Immediately switch off and unplug the
machine, and contact your Customer Support
Center.
To prevent fire or electric shocks, follow the
instruction below based on your machine
configuration. If in doubt, contact your
Customer Support Center.
If your machine is a 200 V or 220-240 V
model, there is no need to attach a
separate earth line
connection is incorporated in the power
line. Plug it into a properly rated outlet.
If your machine is a 100 model, use the
green earth wire bundled with the power
cord located at the rear of the machine.
The earth wire must be connected to one of
the following conductors:
Earth terminal of the specified power
outlet.
A piece of copper buried in the earth 650
mm or deeper.
Earth terminal with Class D* earthing.
* Class D is the regulation for Japan only.
since the earth