Boot Prompt Commands - Nortel 2300 Series Reference

Wlan security switch command line reference

Hide thumbs Also See for 2300 Series:

Table of Contents

Boot Prompt Commands

Boot prompt commands enable you to perform basic tasks, including booting a system image file, from the

boot prompt (boot>). A CLI session enters the boot prompt if WSS Software does not boot successfully or you

intentionally interrupt the boot process. To interrupt the boot process, press q followed by Enter (return).

recommends that you use these commands only when working with Nortel to diagnose a

system issue. In particular, commands that change boot parameters can interfere with an

WSS's ability to boot successfully.

This chapter presents boot prompt commands alphabetically. Use the following table to locate commands in

this chapter based on their use.

Command Information

File Management

Boot Profile

Generally, boot prompt commands are used only for troubleshooting. Nortel

ls on page 594

help on page 593

boot on page 587

reset on page 595

autoboot on page 586

dhcp on page 591

dir on page 592

fver on page 593

version on page 599

show on page 596

create on page 590

next on page 595

change on page 588

delete on page 590

diag on page 592

test on page 599

Nortel WLAN—Security Switch 2300 Series Command Line Reference