Rf Detection Commands - Nortel 2300 Series Reference

RF Detection Commands

WSS Software automatically performs RF detection scans on enabled and disabled radios to detect rogue
access points. A rogue access point is a BSSID (MAC address associated with an SSID) that does not belong
to a Nortel device and is not a member of the ignore list configured on the seed switch of the Mobility Domain.
WSS Software can issue countermeasures against rogue devices to prevent clients from being able to use
them.
You can configure RF detection parameters on individual WSSs.
This chapter presents RF detection commands alphabetically. Use the following table to locate the commands
in this chapter based on their use.
Rogue Information
Countermeasures
Permitted Vendor List
Permitted SSID List
Client Black List
Attack List
Ignore List
AP Signatures
Log Messages
WSS-to-Client RF Link
show rfdetect clients on page 520
show rfdetect mobility-domain on page 526
show rfdetect data on page 524
show rfdetect visible on page 531
show rfdetect counters on page 523
show rfdetect countermeasures on page 522
set rfdetect vendor-list on page 518
show rfdetect vendor-list on page 531
clear rfdetect vendor-list on page 514
set rfdetect ssid-list on page 517
show rfdetect ssid-list on page 530
clear rfdetect ssid-list on page 513
set rfdetect black-list on page 515
show rfdetect black-list on page 519
clear rfdetect black-list on page 512
set rfdetect attack-list on page 514
show rfdetect attack-list on page 519
clear rfdetect attack-list on page 512
set rfdetect ignore on page 515
show rfdetect ignore on page 526
clear rfdetect ignore on page 513
set rfdetect signature on page 517
set rfdetect log on page 516
rfping on page 533
Nortel WLAN—Security Switch 2300 Series Command Line Reference
521