Setup Utility Prompt Descriptions - Nortel 8300 Series Installation And Commissioning Manual

20 Configuration
Configuring the system with the Setup Utility
The Setup Utility prompts you through the configuration process by asking a
series of questions. Answer each question or accept the default by pressing
Enter. Each question shows the default in brackets and the acceptable
parameter options in parenthesis.
The Setup Utility configures the switch with a management IP address and
basic functionality such as enabling FTP, TELNET and TFTP.
After powering up, connecting through the console and logging in with the
default UID (rwa) and Password (rwa), enter the following command:
install
A Welcome to ERS 8000 setup utility message appears saying that
you are about to configure initial configuration of the switch. Part of the
data is stored in the file /flash/boot.cfg and part is stored in the runtime
configuration file flash/config.config.
You are asked if you want to continue (y/n)? Type y for yes.
"Setup utility prompt descriptions" (page 20)
descriptions and the corresponding action to perform for each prompt.

Setup utility prompt descriptions

Prompt
Please provide primary
config-file path
[/flash/config.cfg]:
Please provide primary
image-file path [flash/p80a.img]:
Please provide primary
license-file path
[/flash/license.dat]:
Please add system prompt
[Passport-8300]
Copyright © 2005-2006, Nortel Networks
.
Note 1: You must be connected to the master CPU to use the install
script.
Note 2: After you run the setup utility, remember to reboot the switch.
Press Enter to accept the default (/flash/config.cfg), or enter a
different file name for the primary configuration file. To store
your config file on the PCMCIA card, use /pcmcia/config.cfg.
Specifying the path to the file is optional.
Press Enter to accept the default (p80a.img), or enter a different
file name for the primary image file. Specifying the path to the
file is optional. If the runtime image resides on a PCMCIA card,
you must specify the /pcmcia/filename.
Press Enter to accept the default (/flash/license.dat), or enter
a different file name for the primary license-file. Specifying
the path to the file is optional. If the license file resides on a
PCMCIA card, you must specify the /pcmcia/filename.
Press Enter to accept the default (Passport-8300), or enter a
different string of up to 20 characters.
Nortel Networks Ethernet Routing Switch 8300
Installation and Commissioning — Quick Start
NN46200-100 02.01 Standard
3.0 6 September 2006
gives the setup utility prompt
Action
Nortel Networks Confidential