Examples The following command sets the priority of ports 3 and 4 to 48 on VLAN mauve:
WSS# set spantree portvlanpri 3-4 priority 48 vlan mauve
success: change accepted.
See Also
•
clear spantree portpri on page 390
•
clear spantree portvlanpri on page 391
•
set spantree portpri on page 397
•
show spantree on page 400
set spantree priority
Changes the STP root bridge priority of a WSS on one or all of its VLANs.
Syntax
set spantree priority value {all | vlan vlan-id}
priority value
all
vlan vlan-id
Defaults The default root bridge priority for the switch on all VLANs is 32,768.
Access Enabled.
Examples The following command sets the bridge priority of VLAN pink to 69:
WSS# set spantree priority 69 vlan pink
success: change accepted.
See Also
show spantree on page 400
set spantree uplinkfast
Enables or disables STP uplink fast convergence on a WSS. This feature enables a WSS with redundant links to the
network backbone to immediately switch to the backup link to the root bridge if the primary link fails.
Syntax
set spantree uplinkfast {enable | disable}
enable
disable
Priority value. You can specify a value from 0 through 65,535. The bridge
with the lowest priority value is elected to be the root bridge for the
spanning tree.
Changes the bridge priority on all VLANs.
VLAN name or number. WSS Software changes the bridge priority on
only the specified VLAN.
Enables uplink fast convergence.
Disables uplink fast convergence.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
STP Commands 409