Show Ap Vlan - Nortel 2300 Series Reference

Wlan security switch command line reference

Hide thumbs Also See for 2300 Series:

Table of Contents

RFID Reports

Table 14: Output for show ap status terse and show ap status terse

show ap vlan

Displays information about the VLANs that are either locally switched by the specified AP or tunneled from the AP to

an WSS switch.

Table 13: Output for show ap status (continued)

SSIDs configured on the radio and their BSSIDs.

Status of AeroScout asset tag support.

• Active—The AeroScout Engine has enabled the

tag report mode on the AP.

• Inactive—The AeroScout Engine has not

enabled, or has disabled, the tag report mode on

Note: This field is displayed only if the rfid-mode option is

enabled on the radio profile that manages the radio.

WSS port number connected to the AP.

Operational status flags for the AP.

For flag definitions, see the key in the command output.

IP address of the AP. The address is assigned to the AP by a

DHCP server.

Note: This field is applicable only if the AP is configured on the

WSS as a AP.

AP model number.

MAC address of the AP.

State, channel, and power information for radio 1:

• The state can be D (disabled) or E (enabled).

• The channel and power settings are shown as

channel/power.

State, channel, and power information for radio 2.

Amount of time since the AP booted using this link.

Nortel WLAN—Security Switch 2300 Series Command Line Reference

AP Commands 375