Nortel 2300 Series Reference page 305

set radio-profile qos-mode
Sets the prioritization mode for forwarding queues on AP radios managed by the radio profile.
Syntax
set radio-profile name qos-mode {svp | wmm}
svp
wmm
Defaults The default QoS mode is wmm.
Access Enabled.
History Introduced in WSS Software Version 4.1.
Usage When SVP is enabled, AP forwarding prioritization is optimized for SpectraLink Voice
Priority (SVP) instead of WMM, and the AP does not tag packets it sends to the
classification and tagging remain in effect. (For information, see the "Configuring Quality of
Service" chapter of the
If you plan to use SVP or another non-WMM type of prioritization, you must configure ACLs to tag the
packets. (See the "Enabling Prioritization for Legacy Voice over IP" section in the "Configuring and
Managing Security ACLs" chapter of the
Examples The following command changes the QoS mode for radio profile rp1 to SVP:
WSS# set radio-profile rp1 qos-mode svp
success: change accepted.
See Also
• set radio-profile mode on page 291
• show radio-profile on page 376
set radio-profile rate-enforcement
Configures WSS Software to enforce data rates, which means that a connecting client must transmit at one of
the mandatory or standard rates in order to associate with the AP.
Optimizes forwarding prioritization of AP radios for SpectraLink Voice
Priority (SVP).
Classifies and marks traffic based on 802.1p and DSCP, and optimizes
forwarding prioritization of AP radios for Wi-Fi Multimedia (WMM).
Nortel WLAN Security Switch 2300 Series Configuration
Nortel WLAN Security Switch 2300 Series Configuration
Nortel WLAN—Security Switch 2300 Series Command Line Reference
AP Commands 305
WSS
. Otherwise,
Guide.)
Guide.)