Nortel 2300 Series Reference page 603

fver
Displays the version of a system image file installed in a specific location on a WSS.
Syntax
fver {c: | d: | e: | f: | boot0: | boot1:} [filename]
c:
d:
e:
f:
boot0:
boot1:
[filename]
Defaults None.
Access Boot prompt.
Usage To display the image filenames, use the dir command. This command does not list the
boot code versions. To display the boot code versions, use the version command.
Examples The following command displays the system image version installed in boot partition
1:
boot> fver boot1
File boot1:default version is 1.1.0.98.
See Also
• dir on page 592
• version on page 599
help
Displays a list of all the boot prompt commands or detailed information for an individual command.
Syntax
help [command-name]
command-name
Defaults None.
Access Boot prompt.
Usage If you specify a command name, detailed information is displayed for that command. If
you do not specify a command name, all the boot prompt commands are listed.
Nonvolatile storage area containing boot partition 0 (primary).
Nonvolatile storage area containing boot partition 1 (secondary).
Primary partition of the flash card in the flash card slot.
Secondary partition of the flash card in the flash card slot.
Boot partition 0.
Boot partition 1.
System image filename.
Boot prompt command.
Nortel WLAN—Security Switch 2300 Series Command Line Reference
Boot Prompt Commands 603